-
« Home
Pages
-
RSS Feeds
Tag Archives: Rhinoceros
Table Mockup
16-Jun-10Triaxial Weaving Progress
01-Feb-10The process of triaxial weaving illustrated
Different variations of the component, controlled by the parameters in grasshopper.
Image showing the component applied on a surface. The division/ application on the surface can be varied parametrically using law curves.
The variations on the surface illustrated
Photographs of the weaving pattern tried with 1″ wide strips of 3mm thick plywood.
Triaxial Weaving and Plain Weaving
23-Dec-09The method of construction of triaxial weave:
‘Sparse triaxial weaving uses three sets of parallel fibres, known as the warp, the whug and the weft. The whug is not present in conventional rectangular weaving. During construction it acts very much like a second warp. The warp can be laid down in simple parallel lines. The whug [...]
Pavilion
23-Dec-09I feel this is a parametric form more suitable for the technique used.
Table Update
23-Dec-09Some improved images of table design mentioned in http://blog.asd-ddrs.org/deepthivijaykumar/2009/12/09/parametric-table/
Jonas mentioned that I need to improve my graphics – suggestions pls!
Parametric Table
09-Dec-09As suggested by Jonas, I was trying out designs for a table, using the aforementioned pattern.
I did try to make it completely parametric, but the file gets really heavy and crashes [tried on a couple of systems]. So I had to go back to the method used in previous posts.
A trial having 3supports.
One of the [...]
Pavilion
08-Dec-09A concept for pavilion…
Still need to develop a lot further – but at this stage itself, a message pops up saying ‘out of memory, will close now’…!?!?
Rendering Experiment
29-Nov-09Just abusing the newly discovered tool – VRay for Rhino
The actual coponent is a rhino model, but I have applied it onto the surfaces using grasshopper – ’semi-parametric’ if you will!
Plain Weave [WIP]
16-Nov-09Continuing from my previous post, shown below is the WIP of my trial at generating a ‘plain weave’ in grasshopper. I started off with a basic sketch of the plain weave.
Then I tried to build it geometrically in grasshopper, only to realize that it doesn’t give the desired effect! A simplified version in Rhino made [...]